Yeah wouldn't you be proud to work at Greenhoe?
donald
http://corvetteaddiction.com/82ce/forum/ |
|
| cross over tube http://corvetteaddiction.com/82ce/forum/viewtopic.php?f=1&t=57 |
Page 1 of 1 |
| Author: | aquila [ Tue Oct 26, 2004 12:06 am ] |
| Post subject: | cross over tube |
I think I have asked this before but thought I would try again. Does anyone know where to get the crossover tube (comes from the drivers side manifold and goes over the front of the engine)? It is a discontinued item and mine has a crack in it. Someone had a couple a while back but had got rid of them. Any help would be appreciated. Thanks, Tom |
|
| Author: | ddbjr [ Tue Oct 26, 2004 7:36 am ] |
| Post subject: | |
Two places have them Bill Hodel his number is 330-832-0871 and the last time I checked he wanted $175.00. Then there is Greenhoe 330-723-0899 and they want $175.00 also. How bad is it cracked, can it be welded? donald |
|
| Author: | aquila [ Tue Oct 26, 2004 8:28 am ] |
| Post subject: | cross over tube |
Thanks for the names. I thought about welding it, the crack is about 1" long and kind of smashed in a little bit. I may give it a try first. Is Greehoee a company? Thanks, Tom |
|
| Author: | ddbjr [ Tue Oct 26, 2004 11:54 am ] |
| Post subject: | |
Yeah wouldn't you be proud to work at Greenhoe?
donald |
|
| Author: | macguyver [ Wed Oct 27, 2004 7:26 pm ] |
| Post subject: | crossover tube |
Dont know about Mr Bill Hodel, But I do know Greenhoes want a LOT of green for just about anything they have.The are way overpriced.If you do a lot of legwork(actually Fingerwork) you can find just about anything you need. Try using J.B. weld ,I have had good results with that on items similer to that. |
|
| Author: | ddbjr [ Wed Oct 27, 2004 8:44 pm ] |
| Post subject: | |
They may be proud but the only two I could find, and I have been looking for quite a while were from Greenhoe and Hodel, both are asking the same price. Repairing is always an alternative, brassing sp. is what I suggested first. Pressure is very minimal in that tube. However, if you are trying to Top Flight the car, the alternatives are few. I was luck enough to be able to reuse my old one and have it re-plated. donald |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|